Gvrp Configuration Commands; Display Garp Statistics - HP E4510-48G Command Reference Manual

9

GVRP Configuration Commands

GVRP Configuration Commands

display garp statistics

Syntax
display garp statistics [ interface interface-list ]
View
Any view
Default Level
1: Monitor level
Parameters
interface interface-list: Defines one or multiple Ethernet ports for which the GARP statistics will be
displayed. You can provide up to 10 Ethernet port lists, by each of which you can specify an individual
port in the form of interface-type interface-number, or a port range in the form of interface-type
interface-number1 to interface-type interface-number2, where the end-port number specified by
interface-number2 must be greater than the start-port number specified by interface-number1. If no
ports are specified, this command displays the GARP statistics for all ports.
Description
Use the display garp statistics command to display the GARP statistics of the specified port(s) or all
ports if no ports are specified.
This command displays the statistics about GVRP packets received, transmitted, and dropped on
GVRP-enabled ports. When the system is restarted or after you perform the reset garp statistics
command, the existing packet statistics are cleared and the system starts to collect new GARP
statistics. With the statistics, you can judge whether a GVRP-enabled port is operating normally.
If the number of received and transmitted GVRP packets on the port is the same as that on the
remote port, it indicates that the two ends are transmitting and receiving GVRP packets normally
and no registration information is lost.
If there are dropped GVRP packets on the port, check its registration mode. GVRP packets are
likely to be dropped if the registration mode is fixed or forbidden, because dynamic VLANs cannot
be registered in either of the modes.
Related commands: reset garp statistics.
Examples
# Display GARP statistics on ports GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2.
<Sysname> display garp statistics interface gigabitethernet 1/0/1 to gigabitethernet 1/0/2
9-1