Display Lldp Tlv-Config - HP E4510-48G Command Reference Manual

Field
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1
Port status of LLDP
Admin status
Trap Flag
Rolling interval
Number of neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown
TLV

display lldp tlv-config

Syntax
display lldp tlv-config [ interface interface-type interface-number ]
View
Any view
Default level
1: Monitor level
Parameters
interface interface-type interface-number: Specifies a port by its type and number.
Description
Use the display lldp tlv-config command to display the advertisable TLVs of a port.
If no port is specified, this command displays the advertisable TLVs of each port.
Initialization delay
Delay period to send LLDPDUs
Interval to send traps
Number of the LLDPDUs to be sent successively when a new
neighboring device is detected
LLDP status of port 1
Indicates whether or not LLDP is enabled on the port.
LLDP mode of the port, which can be:
TxRx. A port in this mode sends and receives LLDPDUs.
Rx_Only. A port in this mode receives LLDPDUs only.
Tx_Only. A port in this mode sends LLDPDUs only.
Disable. A port in this mode does not send or receive
LLDPDUs.
Indicates whether or not trap is enabled.
LLDP polling interval. A value of 0 indicates LLDP polling is
disabled.
Number of the LLDP neighbors connecting to the port
Number of MED neighbors connecting to the port
Number of the CDP neighbors connecting to the port
Number of the optional TLVs contained in an LLDPDU sent
through the port
Number of the unknown TLVs contained in a received LLDPDU
5-13
Description