Garp Timer Leaveall - HP E4510-48G Command Reference Manual

aggregate interface, or all ports in a port group.
Use the undo garp timer leave command to restore the default of the GARP Leave timer. This may
fail if the default is beyond the valid value range for the Leave timer.
By default, the Leave timer is set to 60 centiseconds.
Related commands: display garp timer, garp timer join, garp timer leaveall.
Examples
# Set the GARP Leave timer to 100 centiseconds, assuming that both the Join timer and the LeaveAll
timer are using the default.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] garp timer leave 100

garp timer leaveall

Syntax
garp timer leaveall timer-value
undo garp timer leaveall
View
System view
Default Level
2: System level
Parameters
timer-value: Leaveall timer setting (in centiseconds), which must be a multiple of 5 in the range of the
maximum Leave timer on the device (exclusive) and 32765 (inclusive). When the Leave timers on all
ports are set to the default, the value range for the LeaveAll timer is 65 (inclusive) to 32765 (inclusive).
Description
Use the garp timer leaveall command to set the GARP LeaveAll timer.
Use the undo garp timer leaveall command to restore the default. This may fail if the default is
beyond the valid value range for the LeaveAll timer. .
By default, the setting of the LeaveAll timer is 1000 centiseconds.
Related commands: display garp timer, garp timer leave.
Examples
# Set the leaveall timer to 100 centiseconds, assuming that the Leave timer on every port is set to 60
centiseconds.
<Sysname> system-view
[Sysname] garp timer leaveall 100
9-8