Port Hybrid Protocol-Vlan - HP E4510-48G Command Reference Manual

port hybrid protocol-vlan

Syntax
port hybrid protocol-vlan vlan vlan-id { protocol-index [ to protocol-end ] | all }
undo port hybrid protocol-vlan { vlan vlan-id { protocol-index [ to protocol-end ] | all } | all }
View
Ethernet interface view, port group view, Layer-2 aggregate interface view
Default Level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN ID, in the range 1 to 4094.
protocol-index: Protocol index, ranging from 0 to 15, specified by the users or assigned by the system
automatically when the protocol-based VLAN is created. You can use the display protocol-vlan vlan
all command to display the protocol indexes.
to protocol-end: Specifies the end protocol index, ranging from 0 to 15. The protocol-end argument
must be greater than or equal to the beginning protocol index.
all: Specifies all protocols bound with vlan-id.
Description
Use the port hybrid protocol-vlan vlan command to associate the hybrid port(s) with a
protocol-based VLAN.
Use the undo port hybrid protocol-vlan command to remove the association.
In port group view, this command applies to all ports in the port group. For information about port
groups, refer to Ethernet Interface Configuration in the Access Volume.
In Layer-2 aggregate interface view, this command applies to the Layer-2 aggregate interface and
all its member ports. After you perform the configuration, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do
that on the aggregate interface, it stops applying the configuration to the aggregation member
ports. If it fails to do that on an aggregation member port, it simply skips the port and moves to the
next port. For information about Layer-2 aggregate interfaces, refer to Link Aggregation
Configuration in the Access Volume.
Before issuing this command, make sure that you have made the following configurations:
Create a VLAN and associate it with specified protocols.
Configure the link type as hybrid.
Configure the port to allow the protocol-based VLAN to pass through.
Related commands: display protocol-vlan interface.
Examples
# Associate the hybrid port GigabitEthernet 1/0/1 with protocol 0 (IPv4) in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] protocol-vlan ipv4
6-24