HP E4510-48G Command Reference Manual page 98

Default Level
1: Monitor level
Parameters
None
Description
Use the display link-aggregation summary command to display the summary information of all
aggregation groups.
You may find out that information about the remote system for a static link aggregation group is either
replaced by none or not displayed at all. This is normal because this type of aggregation group is not
aware of its partner.
Examples
# Display the summary information of all aggregation groups.
<Sysname> display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e267-6c6a
AGG AGG
Interface Mode
-------------------------------------------------------------------------
BAGG1 S
BAGG10 D
Table 2-4 display link-aggregation summary command output description
Aggregation Interface Type
Aggregation Mode
Loadsharing Type
Actor System ID
AGG Interface
AGG Mode
Partner ID
Partner ID
none
0x8000, 000f-e267-57ad
Field
Select Unselect
Ports Ports
1 0
2 0
Aggregate interface type:
BAGG for a Layer-2 aggregate interface
RAGG for a Layer-3 aggregate interface
Aggregation group type:
S for static link aggregation
D for dynamic aggregation
Loadsharing type:
Shar for load sharing
NonS for non-load sharing
Local system ID, which comprises the system LACP priority
and the system MAC address
Abbreviated name of the aggregate interface
Aggregation group type
System ID of the partner, which comprises the system LACP
priority and the system MAC address
2-7
Share
Type
Shar
Shar
Description