Redirect; Remark Dot1P - HP 6125G Command Reference Manual

<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] filter deny

redirect

Syntax
redirect { cpu | interface interface-type interface-number | next-hop { ipv4-add1 [ ipv4-add2 ] |
ipv6-add1 [ interface-type interface-number ] [ ipv6-add2 [ interface-type interface-number ] ] } }
undo redirect { cpu | interface interface-type interface-number | next-hop }
View
Traffic behavior view
Default level
2: System level
Parameters
cpu: Redirects traffic to the CPU.
interface: Redirects traffic to an interface.
interface-type interface-number: Specifies an interface by its type and number.
next-hop: Redirects traffic to a next hop.
ipv4-add1/ipv4-add2: IPv4 address of the next hop. The ipv4-add2 argument backs up ipv4-add1. If
redirecting traffic to ipv4-add1 fails, the switch redirects the traffic to ipv4-add2.
ipv6-add1/ipv6-add2: IPv6 address of the next hop. The ipv6-add2 argument backs up ipv6-add1. If
redirecting traffic to ipv6-add1 fails, the switch redirects the traffic to ipv6-add2. If the specified next hop
IPv6 address is a link-local address, you must also specify the outgoing interface. Otherwise, you do not
need to specify the outgoing interface.
Description
Use redirect to configure a traffic redirecting action in the traffic behavior.
Use undo redirect to delete the traffic redirecting action.
NOTE:
Redirecting traffic to CPU, redirecting traffic to an interface and redirecting traffic to the next hop are
mutually exclusive with one another in a traffic behavior.
Examples
# Configure redirecting traffic to GigabitEthernet 1/0/1 in the traffic behavior database.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] redirect interface gigabitethernet1/0/1

remark dot1p

Syntax
remark dot1p { 8021p | customer-dot1p-trust }
46