Table of Contents
Advertisement
1 English
NOTICE
Do not connect or operate damaged equipment or equipment with missing parts. Failure to obey can cause
damage to the drive and connected equipment.
NOTICE
Install fuses and an RCM/RCD. Failure to obey can cause damage to the drive.
NOTICE
Do not use unshielded wire for control wiring. Use shielded, twisted-pair wires and ground the shield to the
ground terminal of the drive. Failure to obey can cause electrical interference and unsatisfactory system performance.
NOTICE
Do not allow unqualified personnel to use the product. Before you connect a dynamic braking option to the
drive, make sure that you review "Braking Unit, Braking Resistor Unit Instruction Manual (TOBPC72060001)". Failure to obey
can cause damage to the drive and braking circuit.
NOTICE
Make sure that all connections are correct after you install the drive and connecting peripheral devices.
Failure to obey can cause damage to the drive.
NOTICE
Do not connect phase-advancing capacitors or LC/RC noise filters to the output circuits. Failure to obey can
cause damage to the drive, phase-advancing capacitors, LC/RC noise filters, and leakage breakers (ELCB, GFCI, or RCM/
RCD).
■
Intended Use
This AC drive is electrical equipment that controls the speed and rotational direction of a motor in a commercial
application. Do not use this product for other functions.
1. Read and understand all safety precautions.
2. Wire and ground the drive as specified by all applicable standards and safety precautions.
3. Tightly attach all parts and protective covers.
4. Always use the product in the correct environmental conditions as specified in this manual.
Note:
This product is not designed and manufactured for use in life-support machines or systems.
WARNING
Injury to Personnel. This product is manufactured with strict quality-control guidelines. Install applicable safety
devices to minimize the risk of accidents when installing the product where its failure could cause a life-or-death situation, loss
of human life, or a serious accident or physical injury.
■
Exclusion of Liability
The manufacturer cannot be held responsible for any damages to the product, equipment or persons if this product
is used in any other way than specified in
◆
Moving the Drive
Obey local laws and regulations when moving and installing this product.
CAUTION
Crush Hazard. Do not hold the drive by the front cover or terminal cover. Tighten the screws correctly before
moving the drive. Failure to obey can cause minor to moderate injury.
< 15 kg (33 lbs.)
≥ 15 kg (33 lbs.)
Use the hanging brackets attached to the drive to temporarily lift the drive when you install the drive to a control
panel or wall or when you replace the drive. Do not let the drive stay vertically or horizontally suspended or move
the drive over a long distance while it is suspended.
EN 4
Intended Use on page
Drive Weight
4.
Persons Necessary to Move the Drive
2 + using appropriate lifting equipment
TOMPYEUOQ2A03B AC Drive Q2A Installation and Operation Instructions
1
Advertisement
Table of Contents
