Bi: External Alarm 1 / External Alarm 1; System Runtime Total / Sys Runtime Tot; Bi: External Alarm 2 / External Alarm 2 - Siemens SINAMICS G120XA Operating Instructions Manual

Table of Contents

Advertisement

Parameters
7.3 Parameters
Dependency:
When p2111 is set to 0, the following is initiated:
- all of the alarms of the alarm buffer that have gone [0...7] are transferred into the alarm history [8...63].
- the alarm buffer [0...7] is deleted.
See also: r2110, r2122, r2123, r2124, r2125
Note
The parameter is reset to 0 at POWER ON.
p2112[0...n]

BI: External alarm 1 / External alarm 1

Access level: 3
Can be changed: T, U
Unit group: -
Min:
-
Description:
Sets the signal source for external alarm 1.
Dependency:
See also: A07850
Note
An external alarm is triggered with a 1/0 signal.
r2114[0...1]

System runtime total / Sys runtime tot

Access level: 3
Can be changed: -
Unit group: -
Min:
-
Description:
Displays the total system runtime for the drive unit.
The time comprises r2114[0] (milliseconds) and r2114[1] (days).
After r2114[0] has reached a value of 86.400.000 ms (24 hours) this value is reset and r2114[1] is incremented.
Index:
[0] = Milliseconds
[1] = Days
Dependency:
See also: r0948, r2109, r2123, r2125, r2130, r2136, r2145, r2146
Note
When the electronic power supply is switched out, the counter values are saved.
After the drive unit is switched on, the counter continues to run with the last value that was saved.
p2116[0...n]

BI: External alarm 2 / External alarm 2

Access level: 3
Can be changed: T, U
Unit group: -
Min:
-
Description:
Sets the signal source for external alarm 2.
Dependency:
See also: A07851
Note
An external alarm is triggered with a 1/0 signal.
580
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
Data type: Unsigned32 / Binary
Dynamic index: CDS, p0170
Function diagram: 2546
Factory setting:
1
Data type: Unsigned32
Dynamic index: -
Function diagram: -
Factory setting:
-
Data type: Unsigned32 / Binary
Dynamic index: CDS, p0170
Function diagram: 2546
Factory setting:
1
SINAMICS G120XA converter

Advertisement

Table of Contents
loading

Table of Contents