Table of Contents
Advertisement
Parameters
7.3 Parameters
Recommendation:
r0052.0 Ready for switching on
r0052.1 Ready for operation
r0052.2 Operation enabled
r0052.3 Fault present
r0052.4 Coast down active (OFF2)
r0052.5 Quick stop active (OFF3)
r0052.6 Switching on inhibited active
r0052.7 Alarm present
r0052.9 Control request
r0052.14 Motor rotates forwards
r0053.0 DC braking active
r0053.1 n_act > p2167 (n_off)
r0053.2 n_act <= p1080 (n_min)
r0053.3 I_act > p2170
r0053.4 n_act > p2155
r0053.5 n_act <= p2155
r0053.6 n_act >= n_set
r0053.10 Technology controller output at the lower limit
r0053.11 Technology controller output at the upper limit
NOTICE
The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
Note
DO: Digital Output
Relay output: NO = normally open, NC = normally closed
p0733
BI: CU signal source for terminal DO 3 / CU S_src DO 3
Access level: 2
Can be changed: T, U
Unit group: -
Min:
-
Description:
Sets the signal source for terminal DO 2 (NO: X134.51).
r0747
CU digital outputs status / CU DO status
Access level: 3
Can be changed: -
Unit group: -
Min:
-
Description:
Displays the status of digital outputs.
Bit field:
Bit
00
01
02
03
Note
DO: Digital Output
Relay output: NO = normally open, NC = normally closed
Inversion using p0748 has been taken into account.
430
Signal name
DO 0 (NO: X134. 19 / NC: X134. 18)
DO 1 (NO: X134. 21)
DO 2 (NO: X134. 24)
DO 3 (NO: X134. 51)
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: -
Unit selection: -
Max:
-
1 signal
High
High
High
High
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
Data type: Unsigned32 / Binary
Dynamic index: -
Function diagram: -
Factory setting:
52.7
Data type: Unsigned32
Dynamic index: -
Function diagram: 2130, 2131,
2132, 2133
Factory setting:
-
0 signal
FP
Low
-
Low
-
Low
-
Low
-
SINAMICS G120XA converter
Advertisement
Table of Contents
