Bi: Motorized Potentiometer Manual/Automatic / Mop Manual/Auto; Ci: Motorized Potentiometer Automatic Setpoint / Mop Auto Setpoint; Bi: Motorized Potentiometer Accept Setting Value / Motp Acc Set Val; Ci: Motorized Potentiometer Setting Value / Mop Set Val - Siemens SINAMICS G120XA Operating Instructions Manual
Table of Contents
Advertisement
Parameters
7.3 Parameters
p1041[0...n]
BI: Motorized potentiometer manual/automatic / Mop manual/auto
Access level: 3
Can be changed: T
Unit group: -
Min:
-
Description:
Sets the signal source to change over from manual to automatic when using a motorized potentiometer.
In the manual mode, the setpoint is changed using two signals - raise and lower. In the automatic mode, the setpoint
must be interconnected via a connector input.
Dependency:
See also: p1030, p1035, p1036, p1042
Note
The effectiveness of the internal ramp-function generator can be set in automatic mode.
p1042[0...n]
CI: Motorized potentiometer automatic setpoint / Mop auto setpoint
Access level: 3
Can be changed: T
Unit group: -
Min:
-
Description:
Sets the signal source for the setpoint of the motorized potentiometer in the automatic mode.
Dependency:
See also: p1041
p1043[0...n]
BI: Motorized potentiometer accept setting value / MotP acc set val
Access level: 3
Can be changed: T
Unit group: -
Min:
-
Description:
Sets the signal source to accept the setting value for the motorized potentiometer.
Dependency:
See also: p1044
Note
The setting value (CI: p1044) becomes effective for a 0/1 edge of the setting command (BI: p1043).
p1044[0...n]
CI: Motorized potentiometer setting value / Mop set val
Access level: 3
Can be changed: T
Unit group: -
Min:
-
Description:
Sets the signal source for the setting value for the motorized potentiometer.
Dependency:
See also: p1043
Note
The setting value (CI: p1044) becomes effective for a 0/1 edge of the setting command (BI: p1043).
470
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: p2000
Unit selection: -
Max:
-
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: p2000
Unit selection: -
Max:
-
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
Data type: Unsigned32 / Binary
Dynamic index: CDS, p0170
Function diagram: 3020
Factory setting:
0
Data type: Unsigned32 /
FloatingPoint32
Dynamic index: CDS, p0170
Function diagram: 3020
Factory setting:
0
Data type: Unsigned32 / Binary
Dynamic index: CDS, p0170
Function diagram: 3020
Factory setting:
0
Data type: Unsigned32 /
FloatingPoint32
Dynamic index: CDS, p0170
Function diagram: 3020
Factory setting:
0
SINAMICS G120XA converter
Advertisement
Table of Contents
