Table of Contents
Advertisement
Parameters
7.3 Parameters
15
r8541
CO: Speed setpoint from the IOP in the manual mode / n_set IOP
Access level: 3
Can be changed: -
Unit group: 3_1
Min:
- [rpm]
Description:
For the manual mode: the speed setpoint entered from the IOP is displayed.
p8542[0...15]
BI: Active STW1 in the BOP/IOP manual mode / STW1 act OP
Access level: 3
Can be changed: T
Unit group: -
Min:
-
Description:
For the manual mode: Setting of the signal sources for STW1 (control word 1).
Index:
[0] = ON/OFF1
[1] = OC / OFF2
[2] = OC / OFF3
[3] = Enable operation
[4] = Enable ramp-function generator
[5] = Continue ramp-function generator
[6] = Enable speed setpoint
[7] = Acknowledge fault
[8] = Jog bit 0
[9] = Jog bit 1
[10] = Master control by PLC
[11] = Direction reversal (setpoint)
[12] = Enable speed controller
[13] = Motorized potentiometer raise
[14] = Motorized potentiometer lower
[15] = CDS bit 0
680
Reserved
Yes
Calculated: -
Scaling: p2000
Unit selection: p0505
Max:
- [rpm]
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
No
-
Data type: FloatingPoint32
Dynamic index: -
Function diagram: -
Factory setting:
- [rpm]
Data type: Unsigned32 / Binary
Dynamic index: -
Function diagram: -
Factory setting:
[0] 8540.0
[1] 8540.1
[2] 8540.2
[3] 8540.3
[4] 8540.4
[5] 8540.5
[6] 8540.6
[7] 8540.7
[8] 8540.8
[9] 8540.9
[10] 8540.10
[11] 8540.11
[12] 8540.12
[13] 8540.13
[14] 8540.14
[15] 8540.15
SINAMICS G120XA converter
Advertisement
Table of Contents
