Table of Contents
Advertisement
Description:
Sets the switch off time in hours and minutes for time switch 2 (DTC2).
BO: r8423 = 0 signal:
The condition for the set weekday (p8420) and switch-off time has been fulfilled.
Index:
[0] = Hour (0 ... 23)
[1] = Minute (0 ... 59)
Dependency:
See also: p8409, p8420, r8423
NOTICE
This parameter can only be changed when p8409 = 0.
Note
DTC: Digital Time Clock (timer)
RTC: Real-time clock
r8423.0...1
BO: RTC DTC2 output / RTC DTC2 output
Access level: 3
Can be changed: -
Unit group: -
Min:
-
Description:
Display and binector output for the output of timer 2 (DTC2).
Where a weekday is deactivated, the following applies (p8420):
- the binector output for this timer is inactive (r8423.0 = 0).
Where a weekday is activated, the following applies (p8420):
- the ON/OFF time setting (p8421, p8422) for this timer has an instant effect on the binector output (r8423).
Bit field:
Bit
00
01
Dependency:
See also: p8409, p8420, p8421, p8422
NOTICE
This parameter can only be changed when p8409 = 0.
Note
DTC: Digital Time Clock (timer)
RTC: Real-time clock
p8430[0...6]
RTC DTC3 weekday of activation / RTC DTC3 day act
Access level: 3
Can be changed: T
Unit group: -
Min:
0
Description:
Sets the weekday on which timer 3 is activated (DTC3).
The switch-on/off time is set in p8431/p8432 and the result displayed via binector output r8433.
Value:
0:
1:
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
Signal name
Timer on
Timer ON negated
Weekday deactivated
Weekday activated
Calculated: -
Scaling: -
Unit selection: -
Max:
-
1 signal
Yes
No
Calculated: -
Scaling: -
Unit selection: -
Max:
1
Parameters
7.3 Parameters
Data type: Unsigned16
Dynamic index: -
Function diagram: -
Factory setting:
-
0 signal
FP
No
-
Yes
-
Data type: Integer16
Dynamic index: -
Function diagram: -
Factory setting:
0
677
Advertisement
Table of Contents
