Table of Contents
Advertisement
Corrective maintenance
10.2 Replacing spare parts
Installing the FPI board
1. Align the FPI board to the screw holes.
2. Insert 5 screws (torx 20)
Tightening torque: 1.8 Nm.
3. Plug the IPD.
4. Plug the connectors onto the FPI board.
5. Install the front cover.
6. Insert 2 screws (torx 25) of the front cover.
Tightneing torque: 3 Nm.
The FPI board is installed.
❒
844
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
SINAMICS G120XA converter
Advertisement
Table of Contents
