Copy Drive Data Set Dds / Copy Dds; Bi: Drive Data Set Selection Dds Bit 0 / Dds Select., Bit 0; Bi: Drive Data Set Selection Dds Bit 1 / Dds Select., Bit 1; Motor Changeover Motor Number / Mot_Chng Mot No. - Siemens SINAMICS G120XA Operating Instructions Manual

Parameters
7.3 Parameters
p0819[0...2]

Copy Drive Data Set DDS / Copy DDS

Access level: 2
Can be changed: C2(15)
Unit group: -
Min:
0
Description: Copies one Drive Data Set (DDS) into another.
Index: [0] = Source Drive Data Set
[1] = Target Drive Data Set
[2] = Start copying procedure
Dependency: See also: r3996
NOTICE
When the drive data sets are copied, short-term communication interruptions may occur.
Note
Procedure:
1. In Index 0, enter which drive data set is to be copied.
2. In index 1, enter the drive data set data that is to be copied into.
3. Start copying: set index 2 from 0 to 1.
p0819[2] is automatically set to 0 when copying is completed.
p0820[0...n]

BI: Drive Data Set selection DDS bit 0 / DDS select., bit 0

Access level: 3
Can be changed: T
Unit group: -
Min:
-
Description: Sets the signal source to select the Drive Data Set, bit 0 (DDS, bit 0).
Dependency: See also: r0051, p0826, r0837
NOTICE
The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
p0821[0...n]

BI: Drive Data Set selection DDS bit 1 / DDS select., bit 1

Access level: 3
Can be changed: T
Unit group: -
Min:
-
Description: Sets the signal source to select the Drive Data Set, bit 1 (DDS, bit 1).
Dependency: See also: r0051, r0837
NOTICE
The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
p0826[0...n]

Motor changeover motor number / Mot_chng mot No.

Access level: 3
Can be changed: T
Unit group: -
Min:
0
446
Calculated: -
Scaling: -
Unit selection: -
Max:
3
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: -
Unit selection: -
Max:
3
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
Data type: Unsigned8
Dynamic index: -
Function diagram: 8565
Factory setting:
0
Data type: Unsigned32 / Binary
Dynamic index: CDS, p0170
Function diagram: 8565
Factory setting:
0
Data type: Unsigned32 / Binary
Dynamic index: CDS, p0170
Function diagram: 8565, 8570
Factory setting:
0
Data type: Unsigned16
Dynamic index: MDS, p0130
Function diagram: -
Factory setting:
0
SINAMICS G120XA converter