Khp Configuration / Khp Config; Khp Password Input / Khp Passw Input - Siemens SINAMICS G120XA Operating Instructions Manual

Note
KHP: Know-How Protection
Even if know-how protection is set, parameters in this list can be read and written to.
p7765

KHP configuration / KHP config

Access level: 3
Can be changed: T, U
Unit group: -
Min:
-
Description: Configuration settings for know-how protection.
For bit 00, 01:
When KHP is activated, this means that the OEM can define whether the parameters and DCC data encrypted on the
memory card should be protected before using on other memory cards/Control Units.
For bit 02:
This means that the OEM can define whether it is possible or not to trace the drive data using the device trace function
although KHP is activated.
Bit field: Bit
00
01
02
Dependency: See also: p7766, p7767, p7768
Note
KHP: Know-How Protection
For copy protection, the serial numbers of the memory card and/or Control Unit are checked.
The memory card copy protection and preventing data to be traced are only effective when the know-how protection
has been activated.
For bit 00, 01:
If both bits are inadvertently set to 1 (e.g. at the BOP-2), then the setting of bit 0 applies.
There is no copy protection if both bits are set to 0.
p7766[0...29]

KHP password input / KHP passw input

Access level: 3
Can be changed: T, U
Unit group: -
Min:
-
Description: Sets the password for know-how protection.
Example of a password:
123aBc = 49 50 51 97 66 99 dec (ASCII characters)
[0] = character 1 (e.g. 49 dec)
[1] = character 2 (e.g. 50 dec)
...
[5] = character 6 (e.g. 99 dec)
[29] = 0 dec (completes the entry)
Dependency: See also: p7767, p7768
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
Signal name
Extended copy protection - linked to the memory card and CU Yes
Basic copy protection - linked to the memory card
Permit trace and measuring functions for diagnostic
purposes
Calculated: -
Scaling: -
Unit selection: -
Max:
-
1 signal
Yes
Yes
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Parameters
7.3 Parameters
Data type: Unsigned16
Dynamic index: -
Function diagram: -
Factory setting:
0000 bin
0 signal FP
No -
No -
No -
Data type: Unsigned16
Dynamic index: -
Function diagram: -
Factory setting:
-
667