Table of Contents
Advertisement
Parameters
7.3 Parameters
p8402[0...8]
RTC daylight saving time setting / RTC DST
Access level: 3
Can be changed: T, U
Unit group: -
Min:
0
Description:
Setting the daylight saving time.
The factory setting corresponds to the time change for central european summer time (CEST). You only have to set
p8402[0] = 1 to activate CEST.
Index:
[0] = Difference (0 ... 3 hours)
[1] = Start of month (1 ... 12)
[2] = Start of the week of the month (1 ... 4, 6)
[3] = Start of weekday (1 ... 7)
[4] = Start of hour (0 ... 23)
[5] = End of month (1 ... 12)
[6] = End of the week of the month (1 ... 4, 6)
[7] = End of weekday (1 ... 7)
[8] = End of hour (0 ... 23)
Note
The switchover to daylight saving time only effects the RTC and DTC parameters (p8400 ... p8433).
When displaying the fault time and alarm time, the switchover to daylight saving time is not taken into account.
There must be at least two months between the start and end of daylight saving time.
For index 0:
0: daylight saving time switchover deactivated
1 ... 3: time difference
For indices 1 and 5:
1 = January, ... , 12 = December
For indices 2 and 6:
1 = from the 1st to the 7th of the month
2 = from the 8th to the 14th of the month
3 = from the 15th to the 21st of the month
4 = from the 22nd to the 28th of the month
6 = the last 7 days of the month
For indices 3 and 7:
1 = Monday, ... , 7 = Sunday
r8403
RTC actual daylight saving time difference / RTC act DST
Access level: 3
Can be changed: -
Unit group: -
Min:
-
Description:
Displays the actual time difference in hours for the daylight saving time
672
Calculated: -
Scaling: -
Unit selection: -
Max:
23
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
Data type: Unsigned16
Dynamic index: -
Function diagram: -
Factory setting:
[0] 0
[1] 3
[2] 6
[3] 7
[4] 2
[5] 10
[6] 6
[7] 7
[8] 3
Data type: Unsigned16
Dynamic index: -
Function diagram: -
Factory setting:
-
SINAMICS G120XA converter
Advertisement
Table of Contents
