Connecting Converters, Fsd ... Fsg - Siemens SINAMICS G120XA Operating Instructions Manual

Connecting converters, FSD ... FSG

You must remove the connection cover from the converter in order to connect the line supply
and motor to the converter.
● For FSD/FSE, remove the connection cover as shown below:
Figure 4-7
● For FSF/FSG, remove the two screws from the cover and then remove it. In addition, you
must make openings on the connection cover for the line supply and power cables. Use side
cutters or a fine saw blade.
Figure 4-8
After the cables are connected, you must re-attach the cover in order to re-establish the touch
protection of the converter.
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
1
Removing the connection cover, FSD/FSE
1
Removing the connection cover and making openings, FSF/FSG
2
2
Wiring
4.1 Line supply and motor
3
69