Subaru XT 1988 Service Manual page 874

4-3 STEERING SYSTEM
Rotation lock
L4-729
Fig. 51
b. Apply grease to bearing
®
and guide grooves in brackets
@
and @.
3) Install washer
®,
bearing
®
and adjusting screw (tilt)
(j)
to bolt
@.
Apply grease to washer
®
and bearing
® .
L4-730
Fig. 52
4) Force down lower side of column ASSY and hold it on
STAND with CLAMP (926720000). Then, align 20 mm
(0.79 in) dia. hole in bracket
@
and tapered hole in bracket
@.
Install memory pin ASSY
@.
28
STAND
Fig. 53
CLAMP
(926720000)
Move upper side of column ASSV in this condition up and
down several times to see if it moves smoothly.
ADJUSTMENT OF TILT TIGHTENING FORCE
1) Adjust engagement of lever (tilt)
@
so that lever knob is
parallel with column center line when adjusting screw (tilt)
is tightened with lever
@.
Adjusting screw tightening torque:
8 - 10 N·m (0.8 - 1.0 kg·m, 5.8
-7.2
ft-Ib)
After adjustment, install washer
®
and bolt
@.
Bolt tightening torque:
12 - 16 N·m t1.2 - 1.6 kg-m, 9 - 12 ft-Ib)
Parallel
@
L4-732
Fig. 54
Lock and unlock tilt function several times repeatedly to
check that lever operates smoothly.