Subaru XT 1988 Service Manual page 429

ENGINE AND TRANSMISSION MOUNTING SYSTEM 2-11
Before attaching ENGINE SUPPORT to ENGINE SUPPORT
~\
BRACKET and front crossmember, connect adjuster to buffer ~ \
rod ASSY bracket (on engine side).
13) Remove front exhaust pipe.
(1) Disconnect front exhaust pipe from engine.
Remove all nuts except one. (This nut is used to temporarily
hold exhaust pipe.)
(2) Disconnect front-to-rear exhaust pipe connection.
(3) Disconnect front exhaust pipe at transmission and
hanger locations.
(4) Remove the nut which was used to temporarily hold
exhaust pipe in step (1) above, and disconnect front
exhaust pipe.
Fig. 34
14) Remove propeller shaft. (4WD)
a. Before removing propeller shaft, scribe alignment marks on
connections of rear differential companion flange and pro-
peller shaft.
b. Plug the opening at rear of extension to prevent oil from
flowing out.
K==~~=§~~=L2-1169
Fig.
35 -
CD
21
Fig. 35 -
®
15) Remove gear shift system, as follows:
(MIT)
(1) Remove spring.
(2) Disconnect stay CP from transmission.
(3) Disconnect rod CP from transmission.
(A/T)
(1) Disconnect cable from select lever.
(2) Loosen nut which holds cable to bracket.
L2-1171
(3) Disconnect cable while moving inhibitor switch to
2nd position.
L2-1173
Fig. 36