Subaru XT 1988 Service Manual page 1106

Service Instructions for Resin IIuIIIper:
f'R~~st!M;'
~ ~
( ,'!f
~;"
.. :.
Process
No.
2
3
4
5
6
7
S
Process name
Bumpermounting
Masking
t.
Degreasing, cleaning
Primer paint
Drying
Top coat paint
" Drying.
Top coat (II)
• • • -
'.~'"
'<
Set bumper on paint worktable if
required. Use paint worktable
conforming to inner shape of
bumper when possible.
Job contents
Fig. 41
L5-168
Set bumper section
Mask specified part (black
base.
with masking tape. Use masking tape for resin
(example, Nichiban No. 533, etc.). For details, see the following figures.
Clean all parts to be painted with white gasoline, normal alcohol, etc. to remove dirt,
oil, fat, etc.
APhly prim,r one to all parts to be painted, using air gun. Use
wi~er
(clear).
Dry at normal temperature [10 to 15 min. at 20°C (6SoF)).
In half-dried condition. Resin primer paint is dissolved by solvent e.g. thinner, etc.
Therefore, if dust, dirt must be removed, use ordinary alcohol, etc.
Solid color
Use section (block) paint for top coat .
• , Paint In1lJJ8 (for each color)
Metallic color
. (;; i
SoUd
paint~'
• Paint in use (for each color)
Metallic paint
·Hardener PS
Thinner T-301
• Mixing ratio: fy'Iain agent vs.
hardener
=
4 : 1
.V~~\y~1.p",,,,1~ sec/20°C (6SoF)
i.c'r:ifri1°~~~;4_
-
45tL
• Spraying ple'ssure: 245 - 343 kPa
(2.5
~
3.5kg/em 2 , 36 - 50 psi)
.
Noueq~~d.
Not required.
28
Hardener PB
Thinner T-306
• Mixing ratio: Main agent vs.
hardener
=
10 : 1
• Viscosity: 10 - 13 sec/20°C (6SoF)
• Film thickness: 15 -
20tL
• Spraying pressure: 245 - 343 kPa
(2.5 - 3.5 kg/cm2, 36 -50 psi)
Dry at normal temperature [10 min. or
more at 20°C (6SoF)).
In half-dried condition, avoid dust,
dirt.
Apply clear to parts with top coat
(I),
three times at 5 - 7 minute intervals.
• Paint in use
Metallic paint
Hardener PB
Thinner T-301
• Mixing ratio: Clear vs. hardener
=
6: 1
• Viscosity: 14 - 16 sec/20°C (6SoF)
• Film thickness: 25 -
30tL
• Spraying pressure: 245 - 343 kPa
(2.5 - 3.5 kg/cm
2
,
36 - 50 psi)