Subaru XT 1988 Service Manual page 663

3-2
AUTOMATIC TRANSMISSION AND DIFFERENTIAL
(4) With gasket inserted between them, install the exten-
sion case to the transmission case. (Be sure to use a new
gasket.)
a. After inserting the extension case halfway, connect the
connector for duty sol. C. Be careful not to jam the cord in
the case.
b. Be careful not to damage the rear drive shaft seal ring.
(5) Tighten bolts to secure the case.
Tightening torque:
25 ± 2 N·m (2.5 ± 0.2 kg-m, 18.1 ± 1.4 ft-Ib)
FWD model:
(1) Attach the selected aluminum washer to the cover
case with vaseline.
(2) Set the parking return spring.
(3) With gasket inserted between them, install the cover
case to the transmission case.
a. Be sure to use a new gasket.
b. Install the case while ensuring proper alignment of the
bearing, parking shaft, and reduction driven gear.
(4) Tighten bolts to secure the case.
Tightening torque:
25 ± 2 N·m (2.5 ± 0.2 kg-m, 18.1 ± 1.4 ft-Ib)
7. INSTALLATION OF EXTERIOR PARTS
1) Install the revolution sensor. (4WD only)
Tightening torque:
7 ± 1 N·m (0.7 ± 0.1 kg-m, 5.1 ± 0.7 ft-Ib)
2) Installation and adjustment of inhibitor switch:
(1) Install the inhibitor switch to the transmission case.
Fit the projecting portion of the switch in the recessed
portion of the case, and tighten three bolts temporarily.
(2) Insert the range selector lever into the shaft, and
tighten the nut.
Tightening torque:
39 ± 3 N·m (4.0 ± 0.3 kg-m, 28_9 ± 2.2 ft-Ib)
Fig. 269
(3) With the selector lever set to "N" adjust the inhibitor
switch so that the hole of range selector lever is aligned
with the inhibitor switch hole.
STOPPER PIN
(499267300)
~~~~~~~~~~~
L3-780
Fig. 270
(4) With hole aligned, tighten three bolts to secure the
inhibitor switch.
Tightening torque:
3.4 ± 0.5 N·m (0.35 ± 0.05 kg-m, 2.5 ± 0.4 ft-Ib)
3) Clip the following cords and harness:
(1) Transmission harness
(2) Inhibitor switch cord
(3) Revolution sensor cord (4WD only)
4) Install the oil cooler outlet pipe.
Tightening torque:
30.9 ± 3.4 N·m (3.15 ± 0.35 kg-m, 22.8 ± 2.5 ft-Ib)
5) Install the oil cooler inlet pipe.
Tightening torque:
25 ± 2 N·m (2.5 ± 0.2 kg-m, 18.1 ± 1.4 ft-Ib)
Be sure to use a new aluminum washer.
136
~.
c
>
i
t
!
r