Subaru XT 1988 Service Manual page 1054

4-7
AIR CONDITIONING SYSTEM
a. Coat the Q-ring with oil when assembling.
b. Carefully install the SV plate into correct position.
(3) Install the O-rings.
110 mm,
63
mm
Fig.
59
Coat the Q-rings with oil when assembling.
(4) Install the 115 mm O-ring.
Coat the Q-ring with oil when assembling.
(5) Install the cover end (R).
Fig. 60
Cover end (R)
L4-1549
L4-1550
(6) Tighten the 10-mm hexagon socket head bolts togeth·
er with the wave washers using hexagon wrench, torque
wrench and 5-mm hexagon socket wrench.
32
Fig. 61
HEXAGON SOCKET
WRENCH
L4-1551
Tighten bolts lightly by diagonal selection, and finally tighten
to the torque of 19 to 21 N·m (1.9 to 2.1 kg-m, 14 to 15
ft-Ib).
3) Installing shaft seal
(1) Install the cover plate fitted in advance with the 28
mm O-ring in its outer groove into the cover end (F) using
SHAFT SEAL INSTALLER (926120000).
a. Check the Q·ring for damage.
b. Apply oil to the O-ring.
(2) Install 32 mm snap ring using snap ring pliers.
Fig.
62
32 mm snap
ring
L4-558
Make sure the snap ring is fitted correctly into the groove.
4} Installing clutch ASSY
(1) After installing the stator, install 50 mm wedge ring
using snap ring pliers.