Subaru XT 1988 Service Manual page 901

STEERING SYSTEM
4-3
L4-748
Fig. 130
2) Drive dust seal, back-up ring, V-packing and ball bearing
out of valve housing REMOVE R (926290000) and a press_
Use side A of REMOVER
an,d
do not apply load to the face of
valve housing.
B side--
A side
Fig. 131
ASSEMBLY
REMOVER
(926290000)
Dust seal
Backup ring
V-packing
F-i!'~~+----Ball
bearing
L4-749
a. Before operation, clean all parts to be assembled and tools.
b. Use only genuine SUBARU steering grease.
c. Do not use the parts to be replaced, as shown in NOTE b. of
2) of "CHECKING OIL LEAKING POINTS AND REPLACE·
MENT PARTS".
55
ASSEMBLY OF VALVE ASSEMBLY
1) Apply a coat of grease to valve housing as shown in the
figure, as well as to back-up ring and V-packing (valve
housing).
Fig. 132
Grease
Valve
housing
2) Drive dust seal into
(926300000) and a press.
L4-450
place using INSTALLER
a. Face dust seal in the direction shown in the figure.
b. Apply a coat of grease to the mating surface of INSTALLER
with dust seal to avoid damaging the dust seal.
INSTALLER
(926300000)
Dust seal
L4-451
Fig- 133
3) Drive valve housing V-packing and backup ring with
INSTALLER (926300000) and a press.
a. Pay attention to the direction of Y ·packing and the order of
installation as shown in the figure. Otherwise, oil leakage may
result.
b. Apply a coat of grease to the mating surface of INSTALLER
with Y ·packing to avoid damaging the Y ·packing.
c. To facilitate installation, attach Y ·packing and backup ring
to INSTALLER and insert into valve housing before using a
press.