Pedal System And Control Cables - Subaru XT 1988 Service Manual

I
,
PEDAL SYSTEM AND CONTROL CABLES 4-5
5) Pull out accelerator inner cable to its maximum stroke,
and attach it to accelerator pedal.
Pull accelerator cable from throttle body side.
Be careful not to kink accelerator cable.
6) Connect electrical connectors for stop light switch, etc.
7) Install steering column as before.
8) Connect accelerator cable to throttle body.
9
Make sure to check operation of accelerator cable by operating
accelerator pedal by hand.
9) Attach clutch cable grommet to toe board, and then
connect clutch cable to clutch release fork.
Never fail to cover outer cable end with boot.