Subaru XT 1988 Service Manual page 799

4-1
SUSPENSION
L4-170
Fig.
69
Compressor & Drier Assembly
REMOVAL
( I •.
f
0
1\ __
Inserting position
0
\_
~hese
five pipes is not
ql
Important. L4-856
Fig. 70
1) Remove front left wheel.
2) Remove front half portion of mud guard.
3) Using AIR PIPE REMOVER (926520000). disconnect
five air pipes from drier.
4) Remove coupler.
5)
Remove compressor & drier ASSY from engine compart-
ment by loosening four nuts.
42
DISASSEMBLY
Disassemble compressor
&
drier ASSY to compressor, drier,
and bracket by removing bolts, etc.
a. Disassemblv of both compressor and drier is not allowed.
If trouble should occur, replace faulty unit as an ASSY.
b. Make sure that O-rings are free from foreign matter such as
dirt and dust, and coat with grease before reassembling.
Tightening torque: N'm (kg-m, ft-Ib)
T1: 5 - 8 (0.5 - 0.8, 3.6 - 5.8)
T2: 3 - 5 (0.3 - 0.5, 2.2 - 3.6)
Fig.
71
ASSEMBLY AND INSTALLATION
L4-857
Reverse the sequence of removal and
disass~mbly
procedures.
Observe the following:
Make sure that O-rings are free from foreign matter such as
dirt and dust, and coat with grease before reassembling.