Subaru XT 1988 Service Manual page 661

3-2
AUTOMATIC TRANSMISSION AND DIFFERENTIAL
(2) With gasket inserted, secure the oil pan by tightening
20 bolts.
Tightening torque:
3.9
±
0.5 N·m (0.4
±
0.05 kg-m, 2_9
±
0.4 ft-Ib)
Tighten the bolts evenly.
Fig. 267
5. EXTENSION CASE
1) Install the filter in the extension case.
Pay attention to the orientation of the filter.
2) Install the transfer clutch valve ASSY, and secure with
four bolts.
Tightening torque:
8
±
1 N·m (0.8
±
0.1 kg-m, 5.8
±
0.7 ft-Ib)
a. Be su re to tighten the going lead with one of these bolts.
b. Be sure to use a new gasket.
3) Install the pipe, and clamp securely.
4) Install the transfer clutch assembly to the case.
a. Be careful not to damage the seal rings.
b. Insert the clutch assembly fully into position until the
bearing shoulder bottoms.
6. CONNECTION BETWEEN EXTENSION CASE
AND TRANSMISSION CASE
1) Install the revolution sensor to the transmission case with
one bolt. (FWD model only)
Tightening torque:
7
±
1 N·m (0.7
±
0.1 kg-m, 5.1
±
0.7 ft-Ib)
2) I nstall the reduction driven gear.
3) Install the parking pawl and shaft, set the select lever in
the "P" range and tighten the drive pinion lock nut.
Tightening torque:
98
±
5 N·m (10
±
0.5 kg-m, 72.3
±
3.6 ft-Ib)
After tightening, stake the lock nut securely.
4) Install the reduction drive gear ASSY.
Insert it fully into position until the bearing shoulder bottoms.
5) Adjustment of extension end play:
(1) Measure the distance from the transmission case
mating surface to the reduction drive gear end surface.
FWD model: Measure the distance from the transmission case
mating surface to the bearing end face.
134