Subaru XT 1988 Service Manual page 712

3-3 TRANSMISSON CONTROL SYSTEM
6) Assemble the grip cover, spring, and button to selector
lever.
(1) Apply grease on the sliding part of the grip and
button, and spring.
(2)
Insert the spring and button into the grip and then
drive in the spring pin.
Grip
L3-489
Fig.
34
(3) Attach the cover on the grip.
(4)
Insert the grip on the select lever, then tighten screws
to the specified torque with the torque driver.
Tightening torque:
1.3 - 2.6
N·m
(0.13 - 0.27
kg-m,
0.9 - 2.0
ft-Ib)
5 to 6 mm (0.20 to 0.24 in) length screw should be used.
7)
After the completion of fitting, transfer the select lever
to range "P" - "2", pressing the button of the grip; then
check whether the indicator and select lever agree, whether the
pointer and position mark agree and what the operating force
is.
INSTALLATION
1) Mount the select lever ASSY onto the car body.
(1) Apply Butyl rubber (sealing agent) between the select
lever through the hole in the car body and the threaded
fitting hole, and use six bolts for fitting.
Tightening torque:
4.4 -7.4 N·m (0.45 - 0.75 kg-m, 3.3 - 5.4 ft-Ib)
14
Fig.
35
Butyl rubber
(sealing agent)
(2) Set the location of the select lever at "N".
2) Connect the cable ASSY.
L3-490
(1)
Set the location of the selector arm of the transmis-
sion at "N".
(2)
Pass the inner cable through the selector arm pin and
then connect it using a washer and snap pin.
Fig. 36
(3) Attach the outer cable to transmission case with
bolts.
(4) Insert the thread portion of the other inner cable end
into the connector hole of the selector lever, and fix the
other outer cable end to the bracket.
Fig.
37