Subaru XT 1988 Service Manual page 1114

&1
BODY:1AND ',mXl"BRIOR
MuaGuari:l
Exhaust 'Cover'
REMOVAL
REMOVAL
1) Raise front end of vehicle with a jack and remove wheels. 1) Disconnect muffler and exhaust pipe.
:2) Remove screws. and
cliPs
(exCept
:Jt'tGidl~~d::
into :2):< ReJnUfllirexhaustcover.
'fender flange) which hold mud guard. Move mud guard toward!::;,. ; . , : -
~'I""i',,l.;
the center of car body and remove mud guard and c1ips (from
:flange) as a unit. ' .
";(1')' '~:' " . ): ..... .
Clip
~Rivet
screw
INSTALLATION
'Installation
is
In
the reverse ordet of removal.
Be sure to adjust clearances between exhaust cover and
adjacenfbart$ as equally as pOssible'befc,re finally tightening
bolts.
If exhaust cover is deformed or damaged, causing unequal
dearances between it and muffler or exhaust pipe, repair or
replace exhaust cover.
L5-718 . Outer Accessories
Rearview Mirror
Fig. 51
INSTALLATION
REMOVAL
Installation is in the reverse order of removal.
ELECTRICALL V-CONTROLLED TYPE
Only use new nIts and clips.
,MUd
Guard R
2) Remove three screws.
3) Withdraw harness with connector frorn hole in car body.
. '" ~
-.
;-:
REMOVAL
Do not withdraw harness forcibly.
1) Raise rear end of vehicle with a jack and remove wheels.
2) Remove screws and clips (except those inserted into rear 4) Disdihnec'tcohneetors.
quarter outer fl.ange) which hold mud gUilrd.Mo'le mud.guard:
toward the bottom
of
car
body.,:)themrernove mud, . . .
and
Dlttu,t.'fiSHy:cb'nnector baCk \thrb~ltflh'hole. .
clips (from flange) as a unit.
Fig.
52
,
\
~
L5-753
Fig.
53
36