Subaru XT 1988 Service Manual page 1154

5-3 SEATS, SEAT BELTS, AND INTERIOR
SERVICE PROCEDURE
Front Seat
REMOVAL
1) Move front seat all the way back using slide adjuster lever.
2) Remove bolts which hold front section of seat.
3) Move front seat all the way forward.
4) Remove bolt cover from rear end of slide rail on door side.
L5-658
Fig. 21
5) Remove seat anchor cover from rear end of slide rail on
tunnel side.
~CO",OlebO'
r - - - - _ _ _
L5-659
Fig. 22
6) Remove bolts which hold rear section of front seat and
anchor bolt.
12
INSTALLATION
1) Fold backrest forward.
2) Move lower slide rails forward so that front seat is
positioned all the way back.
3) Position front seat and align mounting holes.
4) Tighten bolt which holds front section of seat on tunnel
side (at reference hole).
5) Tighten bolts which hold front section of seat on door
side.
6) Move front seat all the way forward.
7) Tighten bolts which hold rear section of seat on tunnel
side.
8) Similarly, tighten bolts on door side.
9) Tighten anchor bolt.
10) Install bolt cover at rear seat on door side and seat anchor
cover at rear of seat on tunnel side.
11) After properly installing seat, move it back and forth to
make sure slide rails function properly without binding.
Bolt tightening torque:
20 - 39 N·m (2.0 - 4.0 kg-m, 14 - 29 ft-Ib)
Anchor bolt (pinch) tightening torque:
25 - 34 N·m (2.5 - 3.5 kg-m, 18 - 25 ft-Ib)
Tighten bolts in the order designated.
Rear Seat
REMOVAL
1) Remove bolts which hold front of rear cushion to floor.
2) Slightly raise front side of rear seat cushion and push
center rear section down. With seat cushion held in that
position, move it forward until it is unhooked.
L2-298
Fig. 23