Subaru XT 1988 Service Manual page 1139

5-2
DOORS AND WINDOWS
(2) Clean surface of glass to be adhered with alcohol or
white gasoline.
6) Pasting of spacer.
Put new spacer at places where it was removed.
7) Application of primer.
(1) Using a sponge, apply primer to surface of glass to be
adhered.
(2) Likewise, apply primer to area of body to be adhered.
10
mm
(0.39 in)
L5·235
Fig. 51
B.
If primer has dropped onto body finish, it is hard to wipe
off. So protect with masking.
b. Primer must not project from black frame of glaa.
c. After applying primer, I.t it dry spontaneously for about
10 minutes.
d. Do not touch primer·coated surface under any circum·
stances.
8) Application of adhesive.
(1) Cut nozzle tip as shown in figure below.
(2) Open cartridge and put it into a gun with nozzle
attached.
(3) Apply adhesive uniformly to all sides of adhesion
surface while operating gun along glass end face.
10 (0.39)
o
Fig. 52
15
(0.591
10 (0.39)
10
(0.391
Unit:
mm
(in)
L5·236
24
9) Installation of glass.
(1) Hold glass with rubber suction cups.
(2) Mount glass on body.
(3) Stick them firmly together by lightly pressing down.
10) Water leakage test.
After installing glass, test for water leakage after about one
hour.
a. Move vehicle gently.
b. When opening and closing door, lower door glass and move
door gently.
c. Do not squirt strong hose stream on vehicle.
11) Spontaneous drying.
After completing all operations, leave vehicle alone for 24
hours.
When delivering vehicle to user, tell him that vehicle should
not be su bjected to large shocks for at least three days.
12) Install rear pillar cover.
13) Install center pillar cover.
14) Install rear quarter moulding.
15) Install drip moulding.
16) Install lower side mOUlding.
17) Install upper side moulding.
Always install mouldings and covers immediately after install·
ing window glass.