Subaru XT 1988 Service Manual page 480

MANUAL TRANSMISSION AND DIFFERENTIAL 3-1
ASSEMBLY
1) Assemble sleeve & hub ASSY for 3rd-4th and 5th.
Fig. 93
Fig. 94
Two holes for
~.
discrimination
q;
(3rd4th hub) •
t'e'e'
o
G
One hole
for~'
di scrim i nation
(5th hub)
t'e'~
o
G
L3·358
L3-359
2)
In~tall
3rd drive gear CP, balk ring, and sleeve & hub
Groove
L3·132
Fig. 95
5) Drive ball bearing onto the rear section of transmission
main shaft using REMOVER (899714110), 4TH-5TH RACE
INSTALLER (499877000) and a press.
6) Using REMOVER (899714110), 4TH-5TH RACE
INSTALLER (499877000) and a press, install the following
parts onto the rear section of transmission main shaft.
• 5th gear thrust washer
Face thrust washer in the correct direction.
Face this surface
to 5th gear side
ASSY for 3rd4th needle bearing (32 x 36 x 25.7) on trans·
L3·133
mission main shaft. Fig. 96
Align groove in balk ring with shifting insert.
3) Install 4th needle bearing race onto transmission
main shaft using REMOVER (899714110), INSTALLER
(499877000) and a press.
4) Install balk ring, needle bearing (32
x
30
x
25.7). 4th
drive gear CP and 4th gear thrust washer to transmission main
shaft.
Face thrust washer in the correct direction.
47
• 5th needle bearing race
7) Install the following parts to the rear section of trans-
mission main shaft.
• Needle bearing (32
x
36
x
25.7)
• 5th drive gear
• Balk ring
• Sleeve & hub ASSY
• Insert stopper plate
• Lock washer (22 x 38 x 2)
• Tighten lock nuts (22
x
13) to the specified torque using
SOCKET WRENCH (499987003) and TRANSMISSION
MAIN SHAFT HOLDER (498937000).