Subaru XT 1988 Service Manual page 642

AUTOMATIC TRANSMISSION AND DIFFERENTIAL
3-2
3) Install the· dish plate, driven plates, drive plates, and
retaining plate, and secure with the snap ring. (Overrunning
clutch)
Pay attention to the orientation of the dish plate.
Fig. 202
Dish plate
~·=F-.7
{}.
L3-701
4) Install the dish plates, driven plates, drive plates, and
retaining plate, and secure with the snap ring. (Forward clutch)
Pay attention to the orientation of the dish plate.
Snap ring
Dish plate
L3-958
Fig. 203
5) Install the snap ring (for front planetary carrier).
6) Check the forward clutch and overrunning clutch for
operation.
Set the one-way clutch inner race, and apply compressed air
for checking.
Before measuring clearance, place the same thickness of shim
on both sides to prevent retaining plate from tilting.
If the clearance is out of the specified range, select a proper
retaining plate so that the standard clearance can be obtained.
(Forward clutch)
Part No. Thickness mm (in)
31567AA010 8.0 (0.315)
31567AA060 8.2 (0.323)
31567AA070
8.4 (0.331)
31567AA080 8.6 (0.339)
31567AA090 8.8 (0.346)
31567AA100
9.0 (0.354)
(Overrunning clutch)
Part No. Thickness mm (in)
31567AA120 8.0 (0.315)
31567AA130
8.2 (0.323)
31567AA140 8.4 (0.331)
31567AA150
8.6 (0.339)
31567AA160 8.8 (0.346)
31567AA170 9.0 (0.354)
31567AA180
9.2 (0.362)
8) Install the needle bearing, and secure with the snap ring.
Needle bearing
L3-704
7) Checking clearance: Fig. 204
~
Standard value
mm (in)
Forward clutch
0.45 - 0.85
(0.0177 - 0.0335)
Overrunning clutch
1.0 - 1.4
(0.039 - 0.055)
Allowable limit
mm (in)
1.6 (0.063)
2.0 (0.079)
9) Install the one-way clutch (1-2) and plate, and secure with
the snap ring.
Set the inner race. Make sure that the forward clutch is free in
the clockwise direction and locked in the counterclockwise
direction, as viewed from the front of the vehicle.
115