Subaru XT 1988 Service Manual page 1138

DOORS AND WINDOWS 5-2
11) Water leakage test.
Test for water leakage about one hour after installation.
a. Move vehicle very gently.
b. Do not squirt strong hose stream on vehicle.
12) Spontaneous drying.
After completing all operations, leave vehicle alone for 24
hours.
When delivering vehicle to user, ,tell him that vehicle should
not be sUbjected to heavy shocks for at least three days.
13) Install wiper arm.
Rear Window Glass
REMOVAL
1) Remove side upper moulding.
2) Remove side lower moulding.
3) Remove rear pillar cover.
4) Remove upper rear moulding.
5) Remove lower rear moulding.
6) Disconnect terminals of heating wire print.
7) Remove glass in same manner as for windshield.
INSTALLATION
1) Install glass in same manner as for windshield.
2) Install lower rear moulding.
3) Install upper rear moulding.
4) Install rear pillar cover.
5) Install lower side moulding.
6) Install upper side moulding.
7) After installation, test for water leakage after about one
hour and leave vehicle alone for 24 hours.
8) Make heating wire print connections.
Always install mouldings and cover immediately after install-
ing window glass.
Rear Quarter Glass
REMOVAL
1) Remove upper side moulding.
2) Remove lower side moulding.
3) Remove drip moulding.
4) Remove rear quarter moulding.
5) Remove center pillar cover.
6) Remove rear pillar cover.
7) Remove rear quarter glass in same manner as for wind-
shield.
INSTALLATION
1) Removal of spacer, etc.
After cutting layer of adhesive, remove remaining spacers and
two-sided tape securing them to body.
2) Finishing layer surface of adhesive on body.
Using a cutter knife, etc., cut layer of adhesive stuck firmly
to body and finish all sides of layer into plain surface of about
1 mm (0.04 in) in thickness.
23
1
mm (0.04 inl
L5-234
Fig. 50
Work carefully to avoid damaging body coating.
3) Temporary installation of glass.
(1) Apply new spacer and rear quarter glass to see if they
can be put in as before.
(2) If they cannot be, this is because there is an over-
lapping portion. So cut that portion with a putty knife,
etc.
4) Cleaning of body surface.
(1) Remove chips, dirt and dust from body surface.
(2) Clean body wall surface and upper surface of layer of
adhesive with a solvent such as alcohol or white gasoline.
5) Cleaning of glass.
(1) Remove dirt and dust from surface of glass to be
adhered.