Subaru XT 1988 Service Manual page 504

MANUAL TRANSMISSION AND DIFFERENTIAL
3-1
A
[2] Rear Case & Shifter ASSY
DISASSEMBLY
1) Pull out shifter arm CPo
2) Loosen two 6·mm bolts and remove rear case oil guide.
3) Remove back lamp switch ASSY and neutral switch
ASSY.
Replace aluminum gasket with a new one.
A12·270
4) Remove filler with gasket from transmission rear case.
'-F-ig-.-::1-=-8-=-1--------------------J Then remove reverse accent spring and ball (7.1438).
Dimension A
Part Number
Discrimination
mm (in)
stamp
4.50 - 4.63
441347001
T81·1
(0.1772 - 0.1823)
4.37 - 4.50
441347002
T81·2
(0.1720 - 0.1772)
16) Install rear case & shifter ASSY.
Tightening torque:
23 - 26 N'm (2.3 - 2.7 kg·m,
17 -
20 ft·lb)
17) Neutral position adjustment
Reverse accent shaft
Part No.
I denti ficati on
Remarks
Mark
32188AA040 1
Neutral position is
closer to 1 st gear.
32188AA011
No mark
Standard
32188AA050 3
Neutral position is
closer to reverse gear.
See p. 39
18) Reverse check plate adjustment.
See p. 40
19) Install clutch release lever and clutch release bearing.
5) Remove reverse check sleeve ASSY.
6) Disassembling reverse check sleeve ASSY.
ASSEMBLY
1) Install oil seal (18 x 30 x 6) into bore on the back of rear
case using a plastic hammer.
Apply a coat of gear oil to the mating surface and sealing lip
of oil seal beforehand.
71
2) Install oil guide on rear case, and tighten with two 6·mm
bolts.
Tightening torque:
6.4 N'm (0.65 kg·m, 4.7 ft·lb)
Rear case oi I guide
L3·167
Fig. 182