Subaru XT 1988 Service Manual page 702

3-3
TRANSMISSON CONTROL SYSTEM
Knob and Switch
(MT, Selective 4WD)
1) Construction
The switch is soldered to the cord and is held to the knob with
a screw. The cord is routed along the groove in the knob.
The knob is secured to the lever with a spring pin.
2) Operation
When the switch is pressed to ON, the car is set to the 4WD
mode; when it is pressed again, the car is set to the FWD mode.
Depress
-Switch ASSY
Cord ASSY
Knob
Lever CP
Knob groove
L3462
Fig.
3
4