Subaru XT 1988 Service Manual page 465

3-1 MANUAL TRANSMISSION AND DIFFERENTIAL
ASSEMBLY
Replace gaskets with new ones.
1) Assembling parts in transmission case (LH).
CD
Interlock plunger (5.56 x 19.6)
Position two interlock plungers (5.56
x
19.6) in holes on the
inner wall of left transmission case, one interlock plunger in
hole between 1-2 and 34 fork rod holes, and one interlock
plunger in hole between 3-4 and reverse fork rod holes.
o
o
Through hole
~~~©J
L3-349
Fig. 46
®
Reverse idler gear CP
Position reverse shifter lever CP in L.H. transmission case.
Install reverse idler CP and reverse idler gear shaft, and secure
with straight pin (6
x
411).
Be sure to install reverse idler shaft from the rear side.
Fig. 47
®
Reverse fork rod and reverse fork rod arm.
Install reverse arm fork spring, ball (5.5563) and interlock
plunger (5.56
x
19.6) to reverse fork rod arm. Insert reverse
fork rod into hole in reverse fork rod arm, and hold it with
outer snap ring using ACCENT BALL INSTALLER (39941
1700).
32
Apply grease to plunger to prevent it from falling.
®
Plug
Position ball (7.1438). spring and gasket in reverse shifter rod
hole on L. H. transmission case, and tighten checking ball plug.
Tightening torque:
20 N·m (2 kg-m, 14 ft-Ib)
L3-259
Fig. 48
@
Adjustment of reverse idler gear CP position
Move reverse sh ifter rod toward REV side. Adjust so clear-
ance between reverse idler gear CP and L.H. transmission case
wall is 6.0 to 7.5 mm (0.236 to 0.295 in). using reverse shifter
lever CPo
~
L3-350
Fig. 49
Reverse shifter lever CP
Part No.
No. Remarks
32820AAOOO 0 Further from case wall.
32820AA010
-
Standard.
32820AA020 2
Closer to case wall.