Subaru XT 1988 Service Manual page 383

2-8
FUEL SYSTEM
3) If edges of rubber packing are folded toward the inside,
straighten it with a standard screwdriver.
4) Insert fuel filler hose approximately 25 to 35 mm (0.98 to
1.18 in) over the lower end of fuel filler pipe and tighten
clamps. Do not allow clips to touch protector and air vent
pipe.
5) Insert air vent hose approximately 25 to 30 mm (0.98 to
1.18 in) into the lower end of air vent pipe and tighten with
clips, as shown in figure.
L
=
25 - 30
mm
(0.98 -1.18
in)
Air vent tube L2-030
Fig. 12
6) Install protector together with fuel filler pipe. Check to be
sure clamp for filler hose and clip for air vent hose do not
touch apron.
Fuel Separator
REMOVAL
1) Remove right trim from luggage compartment.
2) Remove hose protector.
3) Remove fuel separator and bracket as a unit. Be sure not
to scratch the inner side of car body.
4) Disconnect evaporation tube from pipe held to bracket.
Fig. 13
8
5) Remove fuel separator from bracket.
6) Disconnect tube from fuel separator.
L2-032
Fig. 14
INSTALLATION
Installation is in the reverse order of removal procedures.
Observe the following:
1) When connecting tube between fuel separator and pipe,
insert until it butts up against nipple on the separator side, and
insert the other end up to the marked position on the pipe
side.
2) Install fuel separator on bracket such that the pipe can
run through the hollowed section of separator.
Fig. 15
3) Be sure to insert evaporation tube approximately 15 to
20 mm (0.59 to 0.79 in) into pipe on bracket. Install clips in
a direction which does not touch other tubes.