Subaru XT 1988 Service Manual page 505

3-1
MANUAL TRANSMISSION AND DIFFERENTIAL
3) Assembling reverse check sleeve ASSY.
CD
Install reverse accent shaft, check cam, return spring
and check spring onto reverse check sleeve.
Be sure the bent section of reverse check spring is positioned
in the groove in check cem.
Sleeve
~Shaft
lfrb
~R","," 'P'~:
R " ~ ' " ~",k':!(J; ~
IJ
spring P l a t e ?
y
Snap ring
L3-870
Fig. 183
CV
a. Hook the bent section of reverse check spring
over reverse check plate.
b.
Rotate cam so that the protrusion of reverse
check cam is at the opening in plate.
c. With cam held in that position, install plate onto
reverse check sleeve and hold with snap ring (Inner-
28).
d. Position a-ring (35.4 x 1.5) in groove in sleeve.
Cam
Plate
a. Make sure the cutout section of reverse accent shaft is
aligned with the opening in reverse check sleeve.
b. Spin cam by hand for smooth rotation.
If it does not return properly, replace reverse check spring.
c. Move cam and shaft all the way toward plate and release.
If cam does not return properly, replace reverse check spring;
if shaft does not, check for scratches on the inner surface of
sleeve. If sleeve is in good order, replace spring.
d. Select a suitable reverse check plate by referring to
"Neutral Position Adjustment."
4)
Install reverse check sleeve ASSY to rear case, and tighten
with bolts and washers.
Tightening torque:
10 N'm (1.0 kg-m, 7
ft-Ib)
Reverse check sleeve
L3-168
Fig. 185
5)
Install ball
(7.1438)'
reverse accent spring aluminum
gasket, and plug in that order.
Tightening torque:
10 N'm (1.0 kg·m, 7
ft·lb)
L3·144 L3·169
~----------------------------------~
~1~ ~1M
72