Subaru XT 1988 Service Manual page 1050

4-7
AIR CONDITIONING SYSTEM
(3) Remove the cover end (R) using plastic hammer.
Cover end
(R)
L4·1544
Fig.
47
Slowly withdraw by holding with a hand. If hard to remove,
tap the flange portion lightly by diagonal selection with a
plastic hammer.
(4) Remove the Q·rings.
115 mm, 110 mm
I
63 m m
Do not reuse the removed D·rings.
(5) Remove the cylinder head (R) and SV plate.
a. Do not damage the seat surface.
b. Do not deform the SV plate when removing.
6) Removing cover end (F)
(1) Remove the shell using plastic hammer.
Shell
L4·1545
Fig. 48
a. Place the shell with its clutch side facing up, and pull it off
upward while tapping the flange portion with a plastic
hammer.
b. Use a stand (90 mm cylinder) to facilitate removal of shell.
28
(2) Remove the shell packing.
a. Clean the packing surface of the shell using a knife or the
like.
b. Replace the shell packing with a new one.
(3) Remove the cover end (F).
Cover end (F)
Fig.
49
Cylinder
head
(Fl
(4) Remove the a·rings.
115 mm, 110 mm, 63 mm
Replace the D·rings with new ones.
(5) Remove the cylinder head (F) and SV plate.
a. Do not damage the seat surface.
b. Do not deform the SV plate when removing.
INSPECTION
a. After washing the parts, dry them naturally; avoid use of
compressed air for drying, because water in the air may be
trapped inside the compressor.
b. Check each part visually to see whether it can be used
again by referring to "Disassembled Parts Check List".