Subaru XT 1988 Service Manual page 1009

PEDAL SYSTEM AND CONTROL CABLES
4-5
CLUTCH CABLE (2700
cc)
1) Removal
(1) Disconnect clutch cable on transmission side. Push
grommet into passenger compartment.
(2)
Remove trim panel located under pedal shaft.
(3) Remove a nut at pedal shaft and two bolts which
hold clamp with bracket, and detach clamp.
L4-682
Fig. 15
(4) Remove clip from clevis pin which holds clutch cable
to clutch pedal. Remove clevis pin and clutch cable.
L4·1386
Fig. 16
11
o
Clutch pedal
L4-1387
Fig. 17
(5) Remove spring-hook from bushing.
(6) Remove two bolts which hold pedal switch stopper,
and detach stopper.
(7) Remove clutch pedal.
2) Installation
(1) Apply a coat of grease to frictional/movable sections
of spring bushing and install spring.
(2) Hold clutch pedal to lever.
(3) Install pedal switch stopper.
(4) Connect clutch cable. (Apply a coat of grease to
clevis pin location.)
(5) Install spring.
(6) Align hole at clutch cable end with clamp hole, and
install clamp.
(7) Install trim panel.
(8) Connect clutch cable on transmission side.
(9) Adjust free play of clutch pedal to 10 to 20 mm
(0.39 to 0.79 in).