Subaru XT 1988 Service Manual page 1112

5-1
Process
No.
15
16
17
1S
19
20
21
Process name
Primer surfacer
coating
Drying
Sanding
(III)
Cleaning/degreasing
Topcoating
(I)
Leaving unattended
Topeoating
(II)
BODY AND EXTERIOR
Job contents
Apply a coat of primer surfacer to the repaired area two or three times at an interval
of 3 to 5 minutes.
Recommended surfacer: • UPS 300 Flex Primer
• No. 303 UPS 300 Exclusive hardener
• NPS 725 Exclusive Reducer (thinner)
• Mixing ratio: 2: 1 (USP3oo : No. 303)
• Viscosity: 12 - 14 sec/20°C (6SoF)
• Coated film thickness: 40 - 5010'
Allow the coated surface to dry for 60 minutes at 20°C (6SoF) [or 30 minutes at
60°C (140°F)].
Sand the coated surface and its surrounding areas using #400 sandpaper and water.
Same.
Process No. 12.
Solid
colOr
Use
a
''block'' coating method. ;
• Recommended paint:
Suncryl(SC)
No. 3Q7
>
Flex t-tardaner
SC Reducer (thinner)
• Mixing ratio: 3: 1
JiWacryl :
No. 307),
•
~sity:
11 - t3 sec/20° C (68° F)
• Coated film thickness: 40 - 5010'
• Spraying thickness: 245 - 343 kPa
. (2~6-.3.6 kg/cm 2
,
36 - 50 psi)
Not required.
Not required.
34
Metallic color
+-
+-
+-
+-
• Coated film thickness: 20 - 3010'
+-
leave unattended at 20°C (6SoF) for
at least 10 minutes until the topcoated
area is half-dry.
Be careful to keep dust or dirt from
coming into contact with the affected
.ro.
Apply a coat of clear three times at an
interval of 3 to 5 minutes.
". Recommended paint:
SC710 Overlay Clear
No. 307 Flex Hardener
SC Reducer (thinner)
• Mixing ratio: 3 : 1
(SC710: No. 307)
• Viscosity: 10 - 13 sec/20°C (6SoF)
• Coated film thickness: 20 - 3010'
• Spraying pressure: 245 - 343 kPa
(2.5 - 3.5 kg/cm
2
,
36 - 50 psi)