Subaru XT 1988 Service Manual page 646

AUTOMATIC TRANSMISSION AND DIFFERENTIAL 3-2
4) Remove the snap ring, and take out the spring retainer CPo
PLiER
(399893600)
~
Spring retainer CP
A
I
J
Fig. 216
/
COMPRESSOR
(398673600)
SEAT
(498627000)
~-712
5) Apply compressed air to the rear drive shaft to remove
the piston.
Fig. 218
COMPRESSOR
(398673600)
SEA T (498627000)
)~'---'==
Snap ring
L3-714
3) Install the driven plates, drive plates, and pressure plate,
and secure with a snap ring.
4) Apply compressed air to see if the assembled parts move
smoothly.
L3-715
Fig. 219
L3-713
5) Check the clearance: L -________________________________________
~
Fig. 217 Standard value:
INSPECTION
1) Check the drive plate facing for wear and damage.
2)
Check the snap ring for wear, return spring for permanent
set and breakage, and spring retainer for deformation.
3) Check the lathe cut ring for damage.
ASSEMBLY
1) Install the lathe cut seal ring to the I.D./O.D. of the
transfer clutch piston.
2)
Install the piston and spring retainer, and secure with a
snap ring.
0.2 - 0.9 mm (0.008 - 0.035 in)
Allowable limit: 1.6 mm (0.063 in)
If the clearance is not within the specified range, select a
proper pressure plate.
Before measuring clearance, place the same thickness of shim
on both sides to prevent pressure plate from tilting.
• Available pressure plates
Part No. Thickness mm (in)
31593AA150 3.3 (0.130)
31593AA160 3.7 (0.146)
31593AA170 4.1 (0.161)
31593AA180 4.5 (0.177)
119