Subaru XT 1988 Service Manual page 735

3-4 4WD SYSTEM
A14-018
1 Rear bearing cone
2 REPLACER
(398517700)
Fig. 41 Fig. 43
A14-063
(16) Remove front oil seal from differential carrier.
(11) Draw out pinion mate shaft and remove pinion mate (17) Remove pilot bearing together with front bearing
gears, side gears and thrust washers. cone.
The gears as well as thrust washers should be marked or kept
separated left and right, and front and rear.
(12) Hold companion flange with FLANGE WRENCH
(398427700) and remove drive pinion nut.
(13) Extract the companion flange with a puller.
(14) Press the end of drive pinion shaft and extract it
together with rear bearing cone, preload adjusting spacer
and washer.
Hol.d the drive pinion so as not to drop it.
DRIFT (398467700)
A14-019
Fig. 42
(15) Remove rear bearing cone from drive pinion by
1 DRIFT (398467700)
2 Rear bearing cup
3 Front bearing
4 Pilot bearing
Fig. 44
®
®
A14-021
(18) When replacing bearings, tap front bearing cup and
rear bearing cup in this order out of case by using a brass
bar.
supporting cone with REPLACE R (398517700).
Tap alternately with brass bar.
Place the replacer so that its center-recessed side faces the
A 14-022
pinion gear.
Fig. 45
22