Subaru XT 1988 Service Manual page 1123

5-2 DOORS AND WINDOWS
4) Remove remote handle cover.
5) Remove clip attached to trim panel using CLIP PULLE R
(925580000). Then remove trim panel. Be careful not to
break clip by applying undue force.
Fig. 10
INSTALLATION
Installation is in the reverse order of removal.
a. When installing trim panel, check clip, hold the clip section
down by hand, and push into place.
b. Adjust so that remote cover and trim panel do not overlap,
and install remote cover clip to remote ASSY.
Sealing Cover
REMOVAL
1 ) Remove trim panel.
2) Disconnect harness connectors for remote control rear-
view mirror and power window (optional).
3) Loosen screws which hold speaker, and remove speaker
and harness connector as a unit.
4) Remove remote ASSY.
6) Remove remote clip.
6) Remove door trim bracket.
7) Remove sealer with a spatula.
L5-263
Fig. 11
8
Be careful because cover may break if sealer is removed
forcefully.
INSTALLATION
1) Confirm that sealer is properly applied without breaks.
Then install sealing cover.
2) When repairing or replacing sealing cover, use "Cemedine
5430L" as sealer. It may be overlaid on existing sealer.
Any breaks in sealer applied can cause water leakage or entry
of air and dust. Be sure scaler is applied in a continuous line.
Checker
REMOVAL
1) Remove trim panel.
2) Remove speaker ASSY.
3) Remove sealing
cover.
4) Apply a cloth to door and body to prevent damaging
them and remove checker pin by driving it upward.
Be careful not to damage door and body.
5) Completely close door glass.
6) Loosen two nuts securing checker, and take out checker
through access hole in underside.
Remove carefully to avoid damaging checker cover.
INSTALLATION
Installation is in the reverse order of removal.
Tightening torque:
6.4 - 9.3 N'm (0.66 - 0.96 kg-m, 4.0 - 6.9 ft-Ib)