Subaru XT 1988 Service Manual page 1124

DOORS AND WINDOWS 5-2
Inner Remote Assembly
REMOVAL
1) Remove trim panel.
2)
Remove sealing cover
3)
Disconnect joints of two rods with latch.
4)
Remove screws holding remote ASSY. Then remove rods
from remote clip by pulling them out.
Inner remote ASSY
L5-262
Fig. 12
INSTALLATION
1)
Pass two rods through remote clips and rod holes in
sealing cover, and install remote ASSY on instrument panel.
2)
With door locked, hold upper rod to door latch connector
with screws.
3)
Attach lower rod to door latch connector with screws.
L5..Q76
Fig. 13
INSPECTION
1)
Check operation of each part.
2)
Check each sliding part for proper lubrication.
After installation, be sure lock mechanism operates normally.
Tightening torque (screw):
4.4 -7.4 N·m (0.45 - 0.75 kg-m, 3.3 - 5.4 ft-Ib)
Do not pull connector to make this attachment.
Key Lock
Tightening torque (screw):
4.4 - 7.4 N'm (OA6 - 0.76
kg·m, 3.3 -
6.4
ft·lb)
Door Latch
REMOVAL
1) Remove trim panel.
2) Remove seal ing cover.
3) Completely close door glass.
4) Remove remote ASSY from latch.
5) Turn rod holder to disconnect joint between key lock
ASSY and rod.
6) Using a flat-head screwdriver, disconnect joint between
outer handle and adjusting nut.
7) Loosen three screws securing latch, and remove latch
through service hole in bottom.
9
REMOVAL
1) Remove trim panel.
2) Remove sealing cover.
3) Completely close door glass.
4) Remove key lock from door latch rod.
5) Disengage outer handle from door latch rod.
6) Remove outer handle.
7) Remove key lock from outer handle.
INSTALLATION
Installation is in the reverse order of removal.
Install so that key slot in key lock comes to center of hole in
outer handle.