Subaru XT 1988 Service Manual page 463

3-1
MANUAL TRANSMISSION AND DIFFERENTIAL
21) Removing 5th shifter fork
Remove spring pin from 5th shifter fork by driving with
STRAIGHT PIN REMOVER 2 (398791700).
Fig. 40
22) Removing checking ball plugs
Remove three checking ball plugs from main case.
There are spring and ball inside. Replace gasket with a new
one.
23) Removing fork and rod
Using STRAIGHT PIN REMOVER 2 (398791700), drive out
spring pins from 1-2 shifter fork CP and 3-4 shifter fork CP,
and remove 3-4 fork rod and 3-4 shifter fork CPo Then, pull
out 1-2 fork rod and remove 1-2 shifter fork CPo
When removing rod, keep other rods in neutral. Also, when
pulling out spring pin, remove it toward inside of case so that
it may not hit against case.
24) Removing reverse idler gear
Pullout straight pin and reverse idler gear shaft. Then, remove
reverse idler gear CP and washer (15.5 x 21 x T).
When pulling out straight pin, wash off oil and blow air on it
for easy removal.
Fig. 42
25) Removing arm and rod
Remove outer snap ring, and pUllout reverse shifter rod arm
from reverse fork rod. Then take out ball, spring and interlock
plunger from rod.
And then remove rod.
When pulling out reverse shifter rod arm, be careful not to let
ball pop out of arm.
26) Remove reverse shifter lever.
27) Removing differential side retainer ASSY
Using WRENCH ASSY (499787000)' remove differential side
retainer ASSY from transmission case.
'----_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
--=L~3-_=2_15::..J
A 12-020
F~_41 F~_43
30