Subaru XT 1988 Service Manual page 871

STEERING SYSTEM
4-3
ASSEMBLY
Grease:
a. To telescopic sliding portion and memory
pin ASSY; VALIANT M2 (PIN 003608001)
b. To other portion; SUNLIGHT 2
(PIN 003602010)
PIPE ASSEMBLY
1) Insert pin ASSY
®
into column pipe CP
@
from its long
hole. Apply small amount of grease to spring
@,
add insert
spring
@
and boss
@
into pipe so that the notched portion
of boss faces upwards.
Note
Fig. 39
INSTALLER
(926730000)
Grease
L4-718
2) Insert INSTALLER (926730000) in pipe and engage
INSTALLER's protrusion with notched portion of boss
@.
Then, align
5
mm screw hole in boss
@
with
9
mm
(0.35
in)
dia. hole in pipe by turning boss while compressing spring
@.
Fix with bolt
@
from outside. (Align so notched portion
of INSTALLER faces the vertical direction of steering.)
Tightening torque:
2.5 - 4.4 N·m (0.25 - 0.45 kg-m, 1.8 - 3.3 ft·lb)
3) Apply small amount of grease to bearing periphery of pin
ASSY.
4) Apply adhesive (Cemedine 5430) to outer periphery of
bushing (bearing)
@.
Combine bushing
@
and bearing
@ ,
and insert them in the pipe up to the end. Leave a gap of
2 to 3 mm (0.08 to 0.12 in) at end of pipe by prying only
bearing with a screwdriver.
a. Be careful not to allow adhesive to overflow.
b. Apply grease to bearing.
5)
Fit guide (telescopic)
@
in long hole of pipe
@.
Then,
stretch bushing (telescopic)
(@
and insert it securely between
end of pipe and bearing.
The guide
@
should be installed with short-flanged side down.
Fig. 40
Apply adhesive
@-~~s-----t-1'liI
@
®
SHAFT ASSEMBLY
®
o
o
L4-719
1) Apply adhesive (Cemedine 5430) to outer periphery of
bushing (bearing)
@
I
and fit it into housing
@
together with
bearing
@.
Install housing
@,
washer
@,
spring
@
and
washer
@
on shaft CP
@
I
and lock them with snap ring
@.
a. Do not apply grease to the sensor plate slit.
b. Be careful not to damage sensor plate.
®
I
I I I I I I I
t
@@@@@)@@@
/
Sensor plate
L4·1411
Fig. 41
25