Subaru XT 1988 Service Manual page 1022

HEATER AND VENTILATOR
4-6
INSTALLATION
INSTALLATION
Installation is in the reverse order of removal procedures. To install. reverse removal procedures.
Blower ASSY mounting bolt and nuts tightening torque: a. Be sure harnesses are not forcibly pulled or caught in parts.
5.4 to 9.3 N·m (0.55 to 0.95 kg·m, 4.0 to 6.9 ft-lb). b. After installing parts, check to be sure both tilt and
telescopic mechanisms operate properly.
Heater Control (Control
Wing, Temperature Control
Lever and Fan Switch Lever)
Control Wing
REMOVAL
, ) Remove screws wh ich hold lower instrument cover.
2) Remove screws which hold column cover.
3) Remove screws which hold combination switch to control
wing bracket.
L4-599
Fig. 19
4) Remove clips which hold harness to lower section of
meter.
5) Remove holddown band which holds harness to steering
column.
6) Remove bolts which hold control wing. and detach
control wing.
'1
Temperature Control Lever and Fan
Switch Lever (Both parts are installed on
the same base.)
REMOVAL
, ) Remove console box.
(Refer to "Removal" of console box.)
2) Remove each knob of "Temperature Control Lever and
Fan Switch Lever" respectively.
3) Remove screws to take out "Temperature Control Lever
and Fan Switch Lever" as a unit.
~o
Fig. 20
INSTALLATION
Reverse the order of "Removal".
Temperature control cable is preset at factory. Do not remove
it from base.