Subaru XT 1988 Service Manual page 466

MANUAL TRANSMISSION AND DIFFERENTIAL
3-1
®
Clearance adjustment
After installing a suitable reverse shifter lever CP, shift into
Neutral. Adjust so clearance between reverse idler gear CP and
L.H. transmission case wall is 0 to 0.5 mm (0 to 0.020 in),
using washer(s).
Fig. 50
Washer (20.5 x 26 x t)
Part No. Thickness mm (in)
803020151
0.4 (0.016)
803020152
1.1 (0.043)
803020153 1.5 (0.059)
803020154 1.9 (0.075)
803020155 2.3 (0.091)
(j)
Rod and fork
(1) Install interlock plunger (3 x 11.9) onto 3-4 fork rod.
Apply a coat of grease to plunger to prevent it from falling.
(2) Install 3-4 fork rod into 3-4 shifter fork CP via the
hole on the rear of L.H. transmission case. Align the holes
in rod and fork, and drive straight pin (6
x
22) into these
holes using STRAIGHT PIN REMOVER (398791600).
a. Set reverse fork rod to Neutral.
b. Make sure interlock plunger (installed before) is on the
reverse fork rod side.
(3) Install 1-2 fork rod into 1-2 shifter fork CP via the
hole on the rear of L.H. transmission case. Align the holes
in rod and fork, and drive straight pin (6 x 22) into these
holes using STRAIGHT PIN REMOVER (398791600).
REMOVER 2
(398791600)
Fig. 51
a. Set other rods to Neutral.
b. Make sure interlock plunger (5.56 x 19.6) is on the 3-4 fork
rod side.
(4) Install 5th shifter fork CP onto the rear of reverse
fork rod. Align holes in the two parts and drive straight
pin into place.
@
Plug
Position balls (7.1438 mm dia.), checking ball springs and
gaskets into 3-4 and 1-2 rod holes, and install plugs.
L3-352
Fig. 52
Tightening torque:
20 N·m (2 kg-m, 14 ft-Ib)
33