Subaru XT 1988 Service Manual page 1260

6-2
BODY ELECTRICAL SYSTEM
DETAILS OF CONNECTOR TERMINALS
Cruise control unit connector (Body harness side)
,/
CD ® @ @ (j)
@
® ®
@ @ @ @
@
@ @
~
I
Terminal
Color code
Name
Description
No.
CD
LY 4th range set indicator (AT) Voltage is av when set in the cruise control mode.
®
Y
Ignition coil (MT) When the engine is rotating, the ignition pulse signal is outputted.
@
YL Check This terminal is used for checking quality in production line.
If the main switch is turned ON when the ignition switch is ON, the
@
BrW Main switch
battery voltage is outputted to th is term inal.
If the main switch is
turned OFF, no voltage appears on this terminal.
(j)
YR Speed sensor
If speedometer cable is rotated with ignition switch turned ON, the
ON-OFF signal (more than 5V and aV) is outputted repeatedly.
Manual transm ission model:
@
B(AT)
Clutch switch
This terminal is grounded unless clutch pedal is depressed.
GY(MT)
Automatic transmission model:
This terminal is normally grounded.
®
WB Vent valve Signal is inputted to drive vent valve.
@)
B Ground
This terminal is normally grounded by the grounding wire of con-
trol unit.
Voltage is OV when car speed is at least 5 km/h (3 MPH) below the
@
LG 4th range cancel (AT) speed set in the cruise control mode or when accelerating using the
resume switch.
@
BW Inhibitor switch (AT)
This terminal is grounded when selector lever is set to N or P.
It is not grounded if set in any other position.
(i]l
LW Valve common
Battery voltage is outputted from the control unit and fed to each
valve while the cruise control is operating.
@
BR B rake switch
When the ignition switch is ON, the battery voltage is outputted.
If brake pedal is depressed, no voltage is outputted.
@
GB Stop switch
The battery voltage is outputted if the brake pedal is depressed.
If the brake pedal is released, the voltage is OV.
If the set button is depressed with the ignition switch not to ON,
@
WR
Set switch
the battery voltage is outputted. If the switch is released, the
voltage is av.
If the resume switch is turned when the ignition switch is ON, the
@
YB Resume switch battery voltage is outputted. I f the switch is returned, no voltage
is outputted.
50